zest-it logo  Masking Fluid Remover zest-it logo
 
HOME SOLVENTS MEDIUMS BLENDS WAXES STOCKIST BOOKLETS

About Zest-it® Masking Fluid Remover

 Use to remove old and dried-on Masking Fluid from Brushes, Clothes and equipment.
 

masking fluid remover
Zest-it® Masking Fluid Remover

 

.pet 1reusable

Use to remove old and/or dried-on masking fluid from brushes, clothes and equipment.
This method works well for brushes 'stiff' with masking fluid.

Soak the brush in a small amount of Zest-it Masking Fluid Remover for about fifteen minutes, it should look soft and feel 'gooey' to the touch.
Gently roll the filaments between your fingers with kitchen towel or similar to loosen the masking fluid. Remove the 'gooey' masking fluid then wash the brush in Zest-it. Repeat as necessary.

When all masking fluid has been removed, wash the brush and your hands in soap and water until clean. 

Allow the used fluid to stand overnight, decant off and reuse the fluid.

Sizes available - 50 ml only.

Copyright© Jacqui Blackman 2008

low vocbio productno cfc'snot on animals airplaneYes lorryYes ferryYes

 

Back to Products   Artists Adhesive Remover Glue Dot Remover Hinging Tape Remover

 



Copyright 1999 - 2023 © J. & T. Blackman Ltd. All Rights Reserved Worldwide.
The information contained herein is the Intellectual Property of Jacqui Blackman and
J. & T. Blackman Ltd., and is supplied without liability for errors or omissions.
Zest-it ® and its logo are Registered Trademarks.
No part may be reproduced or used except as authorized by contract or other written permission, unless stated otherwise.
The copyright and the foregoing restriction on reproduction and use extend to all media in which the information may be embodied.